我用Jedis jedis = new Jedis("127.0.0.1",6379);可以成功連接,但是我如果把127.0.0.1換成的本機地址如192.168.1.103發現會報錯.
要修改redis.windows.conf的配置文件(說明一下我的redis是在windows版的)
這里要改兩個地方:
我的修改如下
# ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ bind 127.0.0.1 192.168.1.103 # Protected mode is a layer of security protection, in order to avoid that # Redis instances left open on the internet are accessed and exploited. # # When protected mode is on and if: # # 1) The server is not binding explicitly to a set of addresses using the # "bind" directive. # 2) No password is configured. # # The server only accepts connections from clients connecting from the # IPv4 and IPv6 loopback addresses 127.0.0.1 and ::1, and from Unix domain # sockets. # # By default protected mode is enabled. You should disable it only if # you are sure you want clients from other hosts to connect to Redis # even if no authentication is configured, nor a specific set of interfaces # are explicitly listed using the "bind" directive. protected-mode no
上面的代碼可以看到我的修改了哪些東西，之后再嘗試連接一下。
嘗試在本機以及其他主機通過ip來訪問redis服務時，一直出現錯誤，無法通過IP訪問redis服務。
redis.conf文件中配置了訪問限制，通過bind來限制了ip訪問，默認為127.0.0.1
注釋掉bind之后，本地可以通過ip訪問，但是其他主機無法訪問，在redis3之后，有一個protected-mode 參數，默認開啟 yes，改成no，重啟服務即可。
以上為個人經驗，希望能給大家一個參考，也希望大家多多支持腳本之家。
